欢迎访问南通迅达橡塑制造有限公司官方网站!

产品展示Product category

电梯平衡补偿链

您的当前位置:首页 > 产品展示 > 电梯平衡补偿链
WFO全塑电梯平衡补偿链
发布时间:2016-4-18 14:41:46  阅读:2335

WFO全塑电梯平衡补偿链系列,是一种性能优异的产品,给电梯提供一种理想的、可平稳运行的平衡补偿新产品。

产品结构上由电焊锚链、橡塑合成材料的完美结合,形成其独特的功能。其优点是弹性好、弯曲半径小、阻燃、耐老化、耐寒,使用后平稳性能好,噪音低,适用于1.75m/s以上的中高速电梯。

WFO is a new kind of elevator balance compensation chain with excellent performance, it can ensure the elevator working under an ideal and stable state.

Seen from structure, it is the perfect combination of electric-welding anchor chain and composite material

1.安装时应去除平衡链在卷曲过程中产生的螺旋、缠绕状。

2.去除螺旋、缠绕状的方法:当补偿链轿底一段挂好后,开慢车至顶端,量好补偿链所需长度,截断,将补偿链拖在地面的部分卷起扎好,让它离地1米以上,静态悬挂24小时,待放清缠绕后,挂上另一端,当电梯运行几天后,再检查一下补偿链在运行中是否还有螺旋、缠绕现象,如果还存在,则再重复一次。

3.导向装置中心线与悬挂点应在同一垂直线上,防止平衡补偿链与导向装置因摩擦增大产生意外的故障。

4.导向装置安装点距平衡链弯曲底部最小距离为1米,防止因弯曲半径过小产生运动阻力,造成断链。

1.Before installation, it is necessary to straighten the compensation chain, in order to prevent the rubber or plastic from being cracked or peeled by twisting during working.

2. The way to eliminate: After hanging the compensation chain at the bottom of the car, run the elevator to the top slowly. then measure the required length, cut off, roll and warp the length left on the ground, keep it over 1meter from the ground, and hang it for 24 hours statically, till all spirals is released, and then hang another side. After several days of elevator’s working, recheck whether there is any spiral, do it again.

3. The center line of the guiding device should be kept in the same vertical line with the hanging point, to prevent any accidental breakdown caused by the friction between the compensation chain and the guiding device.

4. The minimum distance between the installation point of the guiding device and the bottom of the loop of the compensation chain is one meter, to prevent the broken of the compensation chain caused by little bending radius.

版权所有 © 南通迅达橡塑制造有限公司 苏ICP备2342364号 联系人:王小姐 手机:13083575587
电话:0513-88836619  QQ:1029766754  地址:江苏省南通市海安县三塘工业园铭豪路33号
技术支持:南通乐途网络科技有限公司
13083575587